Toro Genuine Part Exmark Deluxe Suspension Seat Z Master Zero Turn Mower

It does not fit  a 74214 mower.

Yes, it will fit, thank you.

Yes, it is all one piece. It cannot be unscrewed.

This will fit your mower according to Toro. Feel free to call in for further assistance.

Yes, this will fit your mower.

This will fit your mower. The bolt pattern for this seat is 11"x11.5".

Yes, it works on commercial mowers. You can always check your bolt pattern is the same, 11" x 11.5".

This will work on your mower. The seat does have a spot ready for the safety switch but you need to place it there.

Unfortunately, we are unable to ship out of the U.S. Sorry about the inconvenience.

Toro does not show that this seat will fit your model.

This will fit all Z Masters. Unfortunately, we cannot ship out of the USA.

Yes, it will fit your mower. Thank you.

This is compatible with your mower. Thank you!

No, this is only for commercial mowers.

It will fit your model if it is a commercial mower. You can make sure the bolt pattern on the bottom of the seat (11" x 11.5") matches up.

This seat will fit your mower.

Yes, this will fit your mower.

This seat is compatible with your commercial mowers.

Yes, this is to be used on utility trailers.

We have these seats in stock and ready to ship.

Unfortunately, we do not sell Exmark parts.

Yes, this seat will fit any commercial mower.

It should fit your model but you can make sure the bolt pattern on the bottom of the seat (11" x 11.5") matches up.

No, it will not fit on the Toro Timecutter thank you.

No, this seat fits the toro z master only, thank you.

Yes, it will fit, thank you.

The listing is for the complete seat assembly, thank you.

As long as it is a Commercial unit this will interchange.

No, this seat is only for commercial mowers.

The correct measurement is 11"x11.5". Thank you.

The seats weigh around 65 pounds. Give or take!

Unfortunately, we do not have dimensions. We only work by part numbers.

It will fit most of zero turns, the bolt pattern is 11x11.5'', thank you.

No, sorry, this will not fit a Toro MX5000.

Yes this Toro Genuine Part Exmark will fit any Toro commercial mower.

If the ball pattern is the same then yes it will fit, the dimensions on the seat is 11.5" L  X 11"W.

No it does not, you have to take off the old one and install it onto the new one.

If the ball pattern is 11x11 1/2 then it will fit.

Yes this Suspension Seat will fit the 1999 Toro Z-Master 225.

The exact hole pattern on the seat is 11x11.

The bolts on this seat are 11" wide(left to right while sitting on the tractor) by 11.5" long( front to back while sitting on the tractor) You will need to measure the bolts on your existing seat to see if it will fit or be willing to drill 2-3 new holes to make it fit.

This is not an air ride seat, it is a suspension seat.

Bolt pattern is 11x11.

The back does not recline and thers is no lumbar support. The arm rest fold back.

It is made in the US.

Yes, this seat will fit on a Ferris 1500Z.